Log Mill first cut completed

Carter Log Mill

ByMark

Preparing turning blanks at the band saw from logs can be dangerous because the log wants to roll when the blade enters the timber. I have broken a band saw blade trying to cut a hand held log and fortunately was not injured in the process. Carter Products makes a log mill that I have seen demonstrated at woodworking shows so I decided it was time to invest in another shop item that will help me stay safe. After using it the very first time, I know that it was an excellent choice in terms of quality and safety. Below are some photos showing how the contraption works.

Carter Log Mill
The log is held securely between very sturdy adjustable clamp jaws on a heavy steel fence attached to a base that rides in the miter slot of the band saw table. The length is limited to about 20 inches and the diameter to the height of your band saw.
Log Mill First Cut
Here’s another look at the Log Mill as the first cut is about to be made.
Log Mill first cut completed
As you can see, the first pass yields a perfectly flat surface on the log.
Second pass setup
After the first cut, the flat surface is rotated 90 degrees and is placed against the base of the Log Mill where it is again secured with the clamps.
Second pass completed
After the second pass, you now have a log with two flat surfaces at 90 degrees.
Making blanks
At this point, the Log Mill is no longer needed and the standard band saw fence can be used to safely cut blanks.
More blanks
Bowl and spindle blanks can be made to make the best use of the log.
Completed blanks
The Log Mill shown with some turning blanks cut safely with the device.

Similar Posts

  • Salt and Pepper Mills

    ByMark

    There was an article in the Dec/Jan 13 issue of Woodcraft Magazine describing how to make salt and pepper mills using mechanisms purchased at, you guessed it, Woodcraft stores.  This looked like something that would make nice gifts for Marilyn’s side of the family because they were invited to our house for a Christmas party. …

  • Acorn Lidded Box

    ByMark

    One of the great things about wood turning is the variety of things that you can produce on the lathe. Each piece is unique because you, not a computer, control the tool. The way the wood is mounted in relation to the grain determines the tools used to accomplish the task. Lidded boxes are end…

  • Banksia Nut Vase

    ByMark

    The Banksia tree grows in Australia and produces unique looking nuts.  The nuts are harvested and sold as exotic blanks for wood turning.  I have seen these in various woodworking stores so I thought that I would give it a try.  I was surprised when I cut into the nut so I took a few…

  • Natural Edge Bowl

    ByMark

    I had a nice piece of Walnut that was dry enough to try my hand at turning a natural edge bowl. Not just a natural edge bowl, but one that wasn’t round, instead elongated which meant that I would be turning “air” as the cut was interrupted 4 times per revolution until I was deep…

  • |

    Captive Ring Tool

    ByMark

    There are many ways to cut captive rings and specialty tools are sold to accomplish the task. I decided to make my own captive ring tool from an Allen wrench, the tricky part being the shape of the grind. I tried many different shapes without success before hitting one that worked. The various grinds were…